ASTM B/BM: Standard Specification for Aluminum and Aluminum-Alloy Rivet and Cold-Heading Wire and Rods. See the chemical composition and physical properties of ASTM B Grade O Wrought Aluminium, find alternative materials, and connect with suppliers . See the chemical composition and physical properties of ASTM B Grade T6, find alternative materials, and connect with suppliers.
|Published (Last):||20 November 2014|
|PDF File Size:||16.17 Mb|
|ePub File Size:||3.71 Mb|
|Price:||Free* [*Free Regsitration Required]|
Combining values from the two systems may result in non-conformance with the standard.
Link to Active This link will always route to the current Active version of the standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
This specification covers wire and rod asrm the alloys and the tempers suitable for manufacturing rivets and other similar items by cold-heading operations. This abstract is a brief summary of the referenced standard.
Throughout this specification the use of the term alloy in the general sense includes aluminum as well as aluminum alloy. For heat-treated tempers, an inspection lot shall consist of an identifiable quantity of material of the same mill form, alloy, temper, and nominal diameter traceable to a heat-treat lot or lots, and subjected to inspection at one time. Historical Version s – view previous versions of standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
One tension test per specimen shall be taken.
ASTM B Gr Aluminum Wire at Rs /kilogram | Mumbai | ID:
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Resistance to stress corrosion cracking for each lot of specimen shall be established by testing the previously selected tension-test samples for b3316 acceptance purposes.
Samples for chemical analysis shall be taken from the material by drilling, sawing, milling, turning, or clipping a representative piece or pieces to obtain a prepared sample.
For rolled or cold-finished wire and rod, see Specification Band for extruded wire and rod, see Specification B On the other astj, an inspection lot shall consist of an identifiable quantity of material of the same mill form, alloy, temper, and nominal diameter subjected to inspection for non heat-treated tempers. The products covered by this specification shall be produced by extruding, rolling, or drawing, or a combination thereof, at the option of the producer.
ASTM does not give any qstm express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The material shall be supplied in the mill finish and shall conform by the requirements of this specification and shall be commercially sound.
Variations from the specified diameter, length, and straightness shall not exceed the permissible variations prescribed.